How do I remove seized connectors with a connector puller?

Most methods use a rubber mallet to remove the connectors from the tube.

Removing a first-generation connector (USM Haller)
Second-generation connector puller – how to use it (USM Haller)
Pulling a stuck second-generation connector out of the tube (USM Haller)

How to loosen stuck connectors

For slightly stuck connectors, this method is fine. However, if they are more firmly stuck, the method will not work. There is also always a risk of damaging the tubes.

However, the best way to remove the connectors is with our tool. Our tool is inexpensive and very easy to use. With our first and second generation USM Haller connector pullers, loosening stuck connectors is no problem.

You can tell which connector puller is the right one by the connector: in 1st generation furniture (built until around 1990) it consists of three parts (screw, two outer clamps/threads), in the 2nd generation (from around 1990) of two parts (screw with plastic sleeve, external thread). Important: our replacement connectors and all other spare parts only fit the 2nd generation.

This allows not only the connectors to be loosened, but also the complete assembly or disassembly of a USM Haller system to be realized.

From the magazine

All articles